Easy testing procedure 1 Insert the Code Chip with the same bath number into the analyer. Select the sample type to be tested in Setting interface. The default is whole blood. 2 Short press the measurement key and insert the test card. 3 Use a pipette to draw enough blood until the blood reaches the black mark of the pipette. 4 Plug the small hole in the red rubber with the index finger, and gently press to drop the blood into the sample area of the test card. After adding the sample, wait for about 3 minutes to display the test resuit. Application Scenarios Homecare: For chronic disease daity monitoring and management Recommended test cards: Blood glucose + lipid, metabolic diseases screening Clinics, family doctors: For disease screening and diagnosis of patients' conditions. Recommended test cards: Blood glucose + lipid, metabolic diseases screening Analyzer Specifications Sample type Detection time Factory calibrated needs no further calibration Detection time < 3mins Display 43 touch screen Data storage 10000 results Operation environment Temp:15C~35C;Rh:<80% Storage environment Temp: -20'C -60 C; Rh: 10%~90% Power supply DC 5V, 1 A: AC 100V-240V, 50/60Hz; Built-in Lithium battery